|
Reflashing 2008-2011 EvoX AYC-ACD-SAWC ECU |
 |
 |
 |
Reflashing your 2008-2011 Mitsubishi Lancer EvoX AYC-ACD-SAWC ECU
• Reflashable by using MMCFlash "Module3 - LancerX"
• Active Yaw Control, Active Centre Differential, Super All Wheel Control.
• Same as the Outlander XL ACD ecu.
• In MMCFlash select "MH8104F[512K] CAN"
Wiring the openport 2.0 cable directly to the ECU.
| EvoX ACD ECU Pin | OpenPort 2.0 Cable | 12v-15v Power Supply (use a Laptop Power supply if you like, check the voltage) | Description |
pin
pin
|
pin 4 and/or pin 5 |
Negative/Ground (-) |
Vehicle Chassis / Battery Terminal (-) |
pin
|
pin 16 |
+12v |
Battery Backup (Direct 12v) |
pin
|
pin 16 |
+12v
|
Power Supply (comes from MFI Relay) MFI Relay switched on by ecu (via pin ?) |
pin
|
pin 16 |
+12v |
Ignition Switch (comes from IG1 Relay) IG1 switched on by key switch. |
pin
|
pin 12
(OBDII ?)
|
Reflash init line
|
Reflash Init. Voltage from ext. mitsi reflash connector on the OpenPort 2.0 cable. Pin 83 from the ecu actually comes through to pin ? on the OBDII vehicle connector. |
pin
|
pin 7
(OBDII 7)
|
K Line |
K Line Data (used for recovery mode ecuflashing) Pin 74 from the ecu actually comes through to pin 7 on the OBDII vehicle connector. |
2008 Mitsubishi EvoX AYC-ACD-ABS ECU MH8104F
Mitsubishi Outlander XL ACD ECU MH8104F
Read ROM:
step1. plug in openport 2.0 cable.
step2. plug in mmcflash usb dongle
step3. select "MH8104F[512K] can" (2nd option from the bottom)
step4. press Read
Flash ROM: ROM flashed SUCCESS!
Got an EcuFlash XML file for this? Please post it here: 
|
